Rauch AXIS EMC ISOBUS - Application rate

Sub-menu Meaning Description
Distance factor Input of the distance factor from the
fertilizer chart. Required for OptiPoint
calculation
Calculate OptiPoint Input of the GPS control parameters 4.4.10 Calculate OptiPoint
Turn on dist. (m) Input of turn on distance
Turn off dist. (m) Input of turn off distance
GPS-Control info Display of information of the GPS
Control parameters
4.4.11 GPS Control info
Fertiliser chart Management of fertilizer charts 4.4.12 Fertilizer charts
Calibrate AXMAT AXIS-H 50.2 only
Open the sub-menu for calibration of
the AXMAT function
Please observe the operator's
manual for the special
equipment
4.4.1 Application rate
In this menu, you can enter the target value for the desired application rate.
Entering the application rate:
u
Access the menu Fertiliser settings > Appl. rate (kg/ha).
The currently applied application rate is displayed.
u
Enter the new value in the input field.
u
Press OK .
The new value is saved in the machine control unit.
You can also enter or adjust the application rate directly via the working screen.
4. Operation
34
5902180-h-gb- AXIS EMC ISOBUS