Rauch AXIS EMC ISOBUS - System;Test

CAUTION!
Risk of injury due to automatic adjustment of the drop point
With AXIS EMC, the Approach drop pointYes = Start alarm message appears. When you press the
Start/Stop function key, the drop point automatically moves to position 0. After the calibration, the
drop point automatically moves to the preset value again. This may cause injury and property
damages.
▶
Before pressing the Start/Stop key, ensure that nobody is present in the hazard zone of the
machine.
Before storage, you can completely empty the hopper of your machine via the machine control unit.
Complete discharge:
u
Select both sections.
u
Press Start/Stop.
Both metering slides open.
The drop point moves to the left and to the right, to the value 0.
u
Press and hold the Complete discharge button.
The drop point moves between the values 9.5 and 0 to allow the fertilizer to flow out.
u
Release the Complete discharge button.
The left and right drop point moves back to the value 0.
u
Press Start/Stop.
The drop point automatically moves to the pre-set value.
4.7 System/Test
In this menu, the system and test settings for the machine control unit can be configured.
u
Access the menu Main menu > System / Test.
4. Operation
AXIS EMC ISOBUS 5902180-h-gb-
55