Rauch AXIS EMC ISOBUS - Set the working width; Flow factor

u
Press the Appl. rate (kg/ha) [1] button on the touch screen.
The number input window is displayed.
Fig. 13: Entering the application rate on the touch screen
[1] Button Application rate [2] Button Fertiliser chart
u
Enter the new value in the input field.
u
Press OK .
The new value is saved in the machine control unit.
4.4.2 Set the working width
You can set the working width (in meters) in this menu.
u
Access the menu Fertiliser settings > Working width (m).
The currently applied working width is displayed.
u
Enter the new value in the input field.
u
Press OK .
The new value is saved in the machine control unit.
4.4.3 Flow factor
The flow factor lies within the range of 0.2 to 1.9.
4. Operation
AXIS EMC ISOBUS 5902180-h-gb-
35