Rauch AXIS EMC ISOBUS - Page 59

CAUTION!
Risk of injury due to moving machine parts
During the tests, machine parts may move automatically.
▶
Before carrying out the tests, ensure that nobody is present in the danger zone of the
machine.
You can open and close the metering sliders with the up/down arrows.
Example: LIN bus
u
Access the menu System / Test > Test/diagnosis.
u
Select the LIN bus menu item.
The display shows the status of the actuators/sensors.
Fig. 25: System / Test; Example: Test/diagnosis
[1] Status display
[2] Start self-test
[3] Connected equipment
Linbus participant status notification
The devices indicate various conditions:
• 0 = OK; no equipment error
• 2 = blockage
• 4 = overload
4. Operation
AXIS EMC ISOBUS 5902180-h-gb-
59