RayTalk RA-696 - Page 93






 Pinghost(IP):BysendingICMPechorequesttoaspecifiedhostandwaitingfortheresponsetotestthenetwork
status.
 Traceroutingpath:Traceandinquiretheroutingpathtoaspecifictarget.

 Displayinterfacesettings:Itdisplaystheinformationofeachnetworkinterfacesettinginclu dingtheMACaddress,
IPaddress,andNetmask.
 Displaytherouting table: Theinternalrouting table of the system is displayed,whichmay help to confirmthe
StaticRoutesettings.
 DisplayARPtable:TheinternalARPta
bleofthesystemisdisplayed.

 Sniffoninterface:Thisisusedtoconfirmifdatapacketsarepassingthroughtheinterface.

 Displaysystemuptime:Thesystemlifetime(timeforsystembeingturnedon)isdisplayed.

 Checkservicestatus:Checkanddisplaythestatusofthesystem.

 Set device into “safe mode”:This is usedif the administratoris unableto use Web Management Interface via
browser when the system fails inexplicitly.The administratorcan choose this utility and set it into safe mode,
whichenableshimtomanagethisdevicewithbrowseragain.
 Synchronizeclockwi
thNTPserver:ImmediatelysynchronizestheclockthroughtheNTPprotocolandthespecified
networktimeserver.Sincethisinterfacedoesnotsupportmanualsetupforitsinternalclock,wemustresetthe
internalclockthroughtheNTP.
 Print the kernelringbuffer:It is used to examineor controlth
e kernel ring buffer.The program helps users to
printouttheirboot‐upmessagesinsteadofcopyingthemessagesbyhand.
 Mainmenu:Gobacktothemainmenu.


90