React nomadio - Use the Navigation Controls to Adjust the Left End Point as Follows; Trim and EPA Interaction

The position of the pointer on the bar is affected by the steering end point settings (left and right) and
trim setting; increasing the left end point value may visually appear to have the same effect as
decreasing the right end point value.
An end point setting of 100 (the default) is typical for most servos, and should always be used for
ESCs. Larger setting values will overdrive most servos.
Use the navigation controls to adjust the left end point as follows:
1. Access the top function menu from the
driving screen.
2. Navigate to the Steering (Ch1) menu.
or then
3. Navigate to Left End Point.
or
Value Description
0
Minimum left end point; allows NO turning motion
to the left.
1-200
Left end point value is set to a percentage of full
left-turning range.
4. Change the value. or
200
Maximum left end point (will overdrive most
servos)
Trim and EPA Interaction
A trim (or sub-trim) setting of 100 is equivalent to an End point setting of 50.