React nomadio - Adjusting the Low End Point

Adjusting the Low End Point
The low end point value is a relative value, and is expressed as the percentage of full travel to the LOW
end.
Use the navigation controls to adjust the low end point as follows:
1. Access the top function menu from
the driving screen.
2. Navigate to the Channel 3 or
Channel 4 menu.
or then
3. Navigate to Low End Point.
or
Value Description
0 Minimum low end point; allows NO travel to low end.
1-199
Low end point value is set to a percentage of travel
range to low end.
4. Change the value. or
200 Maximum low end point (will overdrive most servos)
Trim and EPA Interaction
A trim (or sub-trim) setting of 100 is equivalent to an End point setting of 50.