3 Web-based Management
Speed & Duplex There are four choices: 10M Half, 10M Full, 100M Half, and 100M
Full.
Flow Control If flow control is enabled on both the local and peer switches. If
congestion occurs on the local switch:
⚫ The local switch sends a message to notify the peer switch to stop sending packets to
itself or reduce the sending rate temporarily.
⚫ The peer switch will stop sending packets to the local switch or reduce the sending rate
temporarily when it receives the message; and vice versa. This allows packet loss to be
avoided and the network service to operate normally.
If it is off, the port runs at full speed.
MTU The maximum transmission unit, in the range of 1518-9216 bytes.
After cli
cking <Apply>, the low
er
part li
sts the port st
atus.
3.2.5 Aggregate Groups
3.2.6 Aggregation
Link aggregation means aggregating several links together to form an aggregation group, so as to
implement outgoing/incoming load balance among the member ports in the group and to enhance
the connection reliability. Depending on different aggregation modes, aggregation groups fall into
three types: manual, static LACP, and dynamic LACP.
3.2.6.1 Aggregation Groups
Configuration steps:
Step 1 Select Trunk ID. There are 13 groups (T1 ~ T13);
Step 2 Specify the trunk name;
Step 3 Specify the trunk type;
Manual: a manual trunk can only be manually set or deleted; LACP can be disabled.
Static: a static LACP trunk can only be manually set or deleted; any port in a static
LACP trunk shall enable LACP protocol. When a static LACP trunk is
(manually) deleted, all ports of this trunk with “up” status will generate one or
more dynamic LACP trunks automatically.
To Next Page
Loading...
Need help?
General