ā Engraver movement
When the engraver is turned on, the engraver begins the self-test in the following order, and it enters into waiting
mode with confirmation sound if there is no problem.
(1) The order of self-test when the machine is turned on
1) If a certain axis is detected by the sensor, move to leave from the detected area.
2) Check probe sensor and return to the Origin point
3) Check Z-axis sensor and return to the Origin point
4) Check X-axis sensor and return to the Origin point
5) Check Y-axis sensor and return to the Origin point
6) Wait for confirmation sound
(2) The sequence of instruction for engraving set up
1) Turn on the engraver.
2) Place to secure the materials to be engraved on the clamp of the engraver.
3) Run the design software (provided with the product).
4) Prepare the contents of engraving.
5) Press the engraving button on the program to transfer intended data to the machine.
6) Press the start button on the machine to begin the engraving process.
To Next Page
Loading...