ON 5V output of
the machine.
※ The port on the backside of
machine can output 5V. It can control the power of buzzer,
vacuum device, etc.
Select the calibration mode.
1. Origin No: 0(Center)~8
User can set and save your own origin.
2. Clamp No: 1~10
For each clamp, you can select 0 ~ 8 origins.
10 clamps can be saved at the maximum.
※The menu cannot be shown in the ring inner/outer diameter
mode. You can use it in flat mode.
Set revolution and speed to spin the rotary chuck.
※ Millgrain tool cab engrave repeated patterns on the ring
outer diameter.
※Millgrain tool is not included. You can purchase at store.
To Next Page
Loading...