Service Program Mode Tables
SM Appendix 4-9 D062/D063/D065/D066
Appendix:
Service
Program
Mode Tables
1904 By-pass Tray Paper Size Correction
Minimum Size
001
Calibrates the minimum paper width position of the sensor (100 mm). Move the
side fences to the 100 mm position then press Execute.
Maximum Size
002
Calibrates the maximum paper width position of the sensor (A3). Move the side
fences to the A3 position then press Execute.
Thick Paper – By-pass Tray
Adjusts the by-pass feed clutch operation for thick paper.
[0 to 1/1/1]
1: On: 30 ms
0: Off:
1905*
This setting switches the by-pass feed clutch on for 30 ms when the registration
motor turns on. It only happens when thick paper is selected, to help this paper
pass through the registration rollers.
1906 Temperature/Humidity Sensor
001 Temperature Sensor
1907 Pre-Fusing Idling On/Off
Pre-fusing idling: The hot roller turns freely to increase its temperature before
thick paper or OHP goes through the fusing unit.
[0 to 1/1/1]
0: Pre-fusing idling is not done.
1: The fusing motor turns the hot roller with no paper in the fusing unit. This
ensures that the hot roller reaches the correct temperature. It is only done for
thick paper or OHP. In this mode, the paper stops at the registration roller, then
To Next Page
Loading...
Need help?
General
