Using the Copier Function
124
4
Copying Both Sides of an ID Card onto One Side of Paper
This section describes how to copy the front and back sides of an ID card, or oth-
er small document, onto one side of a sheet of paper.
When copying onto A4 size paper, you can copy documents that are smaller
than A5 size. Likewise, when copying onto a Letter size paper, you can copy
documents that are smaller than Half Letter size.
Important
❒ This function is only available when the original is set on the exposure glass,
not when it is set in the ADF.
❒ To use this function, the paper size used for printing copies must be set to A4
or Letter.
To use this function, first switch to ID card copy mode for the current job, and
then perform ID card copy.
A Press the {Reduce/Enlarge} key.
B Press the {Reduce/Enlarge} key or {U}{T} keys to select [ID Card Copy], and
then press the {OK} key.
The machine is now in ID card copy mode. Proceed to the following steps to
perform the ID card copy.
C Place the original front side down and top to the machine rear on the expo-
sure glass.
Front
Back
Front
Back
BSP006S
BSP093S
To Next Page
Loading...
