Using the Scanner Function
146
5
C Place the original on the exposure glass or in the ADF.
If necessary, configure advanced scan settings.
D Press the {Start} key.
Depending on the machine's setting, you will see the following screen on the
display.
When in black-and-white scanning mode:
When in color or grayscale scanning mode:
E Press {1} or {2} according to the desired file format.
Depending on the machine's settings, you may see the following screen on the
display when scanning from the exposure glass.
If you see this screen, proceed to step
F
. If not, proceed to step
H
.
F If you have more originals to scan, place the next original on the exposure
glass, and then press {1}. Repeat this step until all originals are scanned.
G When all originals have been scanned, press {2} to start sending the
scanned file.
H Confirm that "Ready" appears on the display.
The scanned file is created in the root directory of the USB flash disk.
I Remove the USB flash disk from the machine.
BSP089S
File Format?
[1]TIFF [2]PDF
File Format?
[1]JPG [2]PDF
Next Scan?
[1]Yes [2]No
To Next Page
Loading...
