Troubleshooting
300
9
BP Tray Print Job Type
Mismatch?Y/N
The paper type set for the doc-
ument differs from the type of
the paper in the tray.
Press the {Start} key to begin
printing, or press the
{Clear/Stop} key to cancel the
job.
Bypass Tray Paper Empty The bypass tray has run out of
paper.
Load paper to the bypass tray.
See p.77 “Loading Paper in
the Bypass Tray”.
Bypass Tray Paper
Misfeed Jam
Paper has been jammed in the
machine.
Remove the jammed paper.
See p.272 “Removing Printing
Jams”.
Cancel Print JOB
I/O TimeOut
The timeout period set in [I/O
Timeout] expires when print-
ing is frequently interrupted
by data from other ports, or
when printing data is large
and takes time for processing.
If [I/O Timeout] is set to 15 sec-
onds, increase the time peri-
od. For details, see p.218
“Machine Settings”.
Cannot Copy
2in1/4in1-Copy Only Support
A4/LT/LG
2-in-1 or 4-in-1 copy could not
be performed because the tray
does not contain the valid size
paper, which are A4, Letter, or
Legal size.
• Set the machine to print
copies using the A4, Letter,
or Legal size paper in the
[Paper Select] setting. See
p.202 “Copy Settings”.
• Specify the A4, Letter, or
Legal size paper for the
tray selected for printing
copies in the [Paper Size]
setting. See p.218 “Ma-
chine Settings”.
Cannot Copy
Insert Paper to ADF
2-in-1, 4-in-1, or 2-sided copy
could not be performed be-
cause the originals were not
placed in the ADF.
• Use the ADF, even when
copying a single sheet.
• If you need to use the ex-
posure glass, turn off
[2in1], [4in1], or [Duplex
Copy] under copy settings,
and then try again. See
p.202 “Copy Settings”.
Connection Fail The line could not be connect-
ed correctly.
• Confirm that the telephone
line is properly connected
to the machine.
• Disconnect the telephone
line from the machine, and
connect a standard tele-
phone in its place. Confirm
that you can make calls us-
ing the telephone. If you
cannot make calls this
way, contact your tele-
phone company.
Message Causes Solutions
To Next Page
Loading...
