Cleaning
315
10
E Wipe the rubber part of the roller with a soft damp cloth. After that, wipe
it with a dry cloth to remove the moisture.
F Reload the removed paper into the tray, and then push the tray carefully
into the machine until it clicks into place.
G Insert the plug of the power cord into the wall socket securely. Connect all
the interface cables that were removed.
H Turn on the power.
Note
❒ If jams or multi-sheet feeds occur after cleaning the friction pad, contact
your sales or service representative.
❒ If the optional tray 2 is installed, clean its friction pads and paper feed roll-
er in the same way as you did for tray 1.
BSP138S
BSP068S
To Next Page
Loading...
