Entering Characters
89
2
• To move the cursor left or right
Press the {U} key to move the cursor left, and the {T} key to move the cursor
right.
If you enter a character when there is a character at the cursor position, the
current character shifts to the right.
• To delete a character
Place the cursor on the character you want to delete, and then press and hold
the {U} key until the character is deleted.
• To delete all characters
Press the {Clear/Stop} key.
Note
❒ Some characters other than digits cannot be used, depending on the setting
you are configuring.
❒ When the maximum number of characters has already been entered, charac-
ters entered subsequently are ignored.
To Next Page
Loading...
