Configuring the WINS Server
The printer can be configured to register its NetBIOS name with a WINS server when the power is turned
on. This enables the NetBIOS name of the printer to be specified from Web Image Monitor even in a DHCP
environment.
This section explains configuring the WINS server.
• The WINS server is supported with Windows 2000 Servers WINS Manager.
• For details about the WINS server settings, see Windows Help.
• If there is no reply from the WINS server, the NetBIOS name is registered by broadcast.
• The NetBIOS name can be entered using up to 13 alphanumeric characters.
Using Web Image Monitor
1. Log in to Web Image Monitor as an administrator.
For details about logging in, see "Access in the Administrator Mode".
2. In the menu area, click [Configuration].
3. Click [Network] and then click [IPv4].
4. Check that [Active] is selected for [WINS] in the [Ethernet + Wireless LAN] column, and then
enter the WINS server IPv4 address in [Primary WINS Server] and [Secondary WINS
Server].
5. Click [OK].
6. Quit Web Image Monitor.
• p.155 "Access in the Administrator Mode"
Using telnet
Use the telnet "wins" command to configure WINS.
• For details, see "Using telnet", UNIX Supplement.
9. Appendix
200
To Next Page
Loading...
Need help?
General
