Ricoh C211 - Page 29

6. ELECTRICAL COMPONENT DESCRIPTIONS
NDEX
NAME
FUNCTION Pto P
No.
LOCATION
Motors
4 Original Transport Motor
Transports the original to the scanner
A-4
section.
11
Master Feed Motor
Feeds the master to the drum.
E-3
16 Cutter Motor
Cut the master.
F-6
19
Master Eject Motor
Sends used master into the master
F-7
eject box.
23 ADF Drive Motor
Feeds the original to the scanner
A-4
section.
(VT2300/2500
only)
30
Image shift Motor
Changes the timing between the paper
F-8
feed roller and the drum to adjust
vertical image position.
36
Paper Table Drive Motor
Raises and lowers the paper table.
F-5
38
Main Motor
Drives paper feed, drum, printing and
F-4
paper delivery
unit components.
66 Air Knife Motor
Rotates the fan to separate the paper
F-7
leading edge from the drum.
67
Vacuum Motor
Provides suction so paper is held firmly
F-5
on the transport belt.
Solenoids
3
Original Pressure Solenoid
Presses the original pressure plate
A-4
down on the originals.
(VT2300/2500
only)
20
Master Eject Solenoid
Moves the master eject roller to contact
F-6
the drum surface.
26
Master Eject Clamper
Opens the master clamp to eject the
F-8
Solenoid
master,
28 Master Feed Clamper
Opens the master clamp to clamp the
F-8
Solenoid master.
31
Reverse Roller Solenoid
Releases the clutch to rotate the
F-6
reverse roller.
35 Paper Feed Solenoid
Releases the paper feed sector gear to
F-8
rotate the paper feed roller.
39
Printing Pressure Solenoid
Moves the press roller against the drum.
F-8
52
Ink Supply Solenoid
Releases the spring clutch to activate
F-7
the ink supply pump.
56 Drum Lock Solenoid
Prevents removal of the drum unit
F-7
unless the drum is at the original stop
position
(This solenoid can be used on the
VT2300/VT2500).
1-16