Ricoh C211 - Page 31

NDEX NAME FUNCTION Pto P
No.
LOCATION
71
Skip Paper Feed Switch Adjusts paper feed interval to allow c-4
(VT2300/VT2500) time for user to remove prints. (VT2300/2500)
Printing Density Switch Use to select the printing density c-3
(VT2100
series)
accordingto the type and qualityof the
(VT21 00/2130
original. /21 50)
72
ADF Safety Switch Check whether the ADF unit is set B-4
correctly or not. (VT2300/2500
only)
Sensors
1
Original Registration
Informs the CPU
when the original
A-3
Sensor leading edge reaches the exposure
glass.
2
2nd Original Sensor Detects when the original is set.
A-3
10
Master End Sensor Informs the CPU when the plotter unit F-6
runs out of master roll.
12 Paper Size Detection Detects the size of the paper set on the
E-5
Sensor 3 paper table. (VT2300/2500
only)
13
Paper Size Detection Detects the size of the paper set on the
E-5
Sensor 2 paper table. (VT2300/2500
only)
14 Paper Size Detection
Detects the size of the paper set on the E-5
Sensor 1 paper table. (VT2300/2500
only)
18 Master Buckle Sensor
Detects the master buckle existence. F-6
22 Master Eject Sensor Detects when the used master is sent F-7
into the master eject box.
(VT2300/2500)
F-6
(VT21 00/2130
/21 50)
24 1st Original Sensor Detects when the original is set in the A-4
ADF mode. (VT2300/2500
only)
33
1st Drum Position Sensor
Checks the position of the drum. F-8
34
2nd Drum Position Sensor
Checks the position of the drum.
F-8
37 Drum Rotation Sensor Supplies timing
pulses to the main F-8
board.
41 1st Paper Exit Sensor
Misfeed detector.
A-5
42
2nd Paper Exit Sensor Misfeed detector. A-5
47
Drum Master Detection Checks whether the master is on the
F-6
Sensor drum.
.
(VT2300/2500
only)
54
Paper Table Height
Detects when the paper table reaches A-6
Sensor
the paper feed position.