2.8 INITIAL CHECK
When the main switch is turned on, the CPU checks the ON/OFF status of
the sensors listed below. If a sensor is ON, the letter on the Jam indicator
corresponding to the sensor blinks:
Master Eject Sensor,,,,,,,,,,,,,.,,,.,..,,,F
Master Buckle Sensor .....................C
2nd Original Sensor ........................A
Original Registration Sensor ..........A
lst/2nd Paper Exit Sensor .,.,.,,.,,,,. G
Printing Pressure Sensor ,,,,,,,,,..,.. ,.,,,,,,,,,,,, ,,,,, E
2.9 MAIN MOTOR SOFT START
The main motor turns at 60 rpm for the first print (not trial print) made from
a new master. The printing speed then gradually increases with each rota-
tion until the standard printing speed is reached.
2-26
To Next Page
