TECHNICAL SERVICE BULLETIN
BULLETIN NUMBER: VT2105/2200 - 007 REISSUE ★
11/08/96
APPLICABLE MODEL: VT2105/2200
SUBJECT: MASTER EJECT BELT MODIFICATION
SYMPTOM:
Master eject jams occur frequently. In the worst case, the upper and lower master eject belts slip off the
rollers.
CAUSE:
During March 1996 production, the vendor that produced the master eject belts was changed. The part
numbers were not changed because there was no change in configuration. However, recently it was found
that the new style master eject belts tend to stretch causing the above mentioned symptom.
SOLUTION:
The vendor has again been changed. The part numbers have been changed as follows:
REFERENCE
OLD
PART
NUMBER
NEW
PART
NUMBER
DESCRIPTION QTY INT
MODEL
VT2105 VT2200
PAGE ITEM PAGE ITEM
C2003545 C2193605 Upper Belt 4 ➝ 4 1 63 9 - -
C2003546 C2193606 Lower Belt 4 ➝ 4 1 63 7 - -
C2193545 C2193605 Upper Belt 4 ➝ 4 1 - - 59 28
C2193546 C2193606 Lower Belt 4 ➝ 4 1 - - 59 29
UNITS AFFECTED:
All VT2105/2200 Priports manufactured after Serial Number C321604XXXX and C340604XXXX respectively
will have the new style Master Eject Belts installed during production.
INTERCHANGEABILITY CHART:
0
OLD and NEW parts can be used in both OLD and
NEW machines.
2
NEW parts CAN NOT be used in OLD machines.
OLD parts can be used in OLD and NEW machines.
1
NEW parts can be used in OLD and NEW machines.
OLD parts CAN NOT be used in NEW machines.
3
OLD parts CAN NOT be used in NEW machines.
NEW parts CAN NOT be used in OLD machines.
3/S
Must be installed as a set on units manufactured prior to the S/N cut-in. On units manufactured aft er the S/N cut-in or
previously modified, use the new part numbers individually.
★
★
★
CUSTOMER SERVICE GROUP
Note: This copy intended as master of original
for reproduction of additional bulletins.
I
To Next Page
