Service Call Conditions
SM Appendix 3-7 D017/D018/D019/D020/D084/D085
Appendix:
Service Call
Conditions
165 B
Copy Data Security Unit error Check installation of Copy
Data Security (CDS) Unit
CDS unit not correct type for
the machine
CDS unit defective
An error occurred when the machine
attempted to recognize the Copy Data
Security Unit board.
202 D
Polygon motor error 1: ON timeout
The polygon mirror motor did not reach the targeted operating speed within
10 sec. after turning on or changing speed
203 D
Polygon motor error 1: OFF timeout
The polygon mirror motor did not leave READY status within 3 sec. after
polygon motor switched off.
204 D
Polygon motor error 1: XSCRDY signal error
The XSCRDY signal remained HIGH for 200 ms while the LD unit was firing.
Polygon motor/driver board harness loose or broken
Polygon motor/driver board defective
Laser optic unit defective
IPU defective
220 D Laser synchronization detection error: LD0
The laser synchronizing detection
signal for the start position of the LD
was not output for two sec. after LDB
unit turned on with the polygon motor
rotating normally.
Laser synchronizing detection
board harness loose or
broken.
Laser synchronization
detection board defective
LDB unit defective
IPU defective
To Next Page
Loading...
