System SP Tables-2
SM Appendix 4-11 D017/D018/D019/D020/D084/D085
Appendix:
Service
Program
Mode
2005* Charge Bias Correction
1
Vsdp Min
Adjusts the lower threshold value for the charge roller correction.
When the value of Vsdp/Vsg is less than this value, the charge roller voltage
increases by 50V (e.g. from –500 to –550). The size of the increase depends
on SP2005 3.
[0 to 100 / 90 / 1%/step]
2
Vsdp Max
Adjusts the upper threshold value for the charge roller correction.
When the value of Vsdp/Vsg is greater than this value, the charge roller
voltage decreases by 50V (e.g. from –550 to –500). The size of the
decrease depends on SP2005 3.
[0 to 100 / 95 / 1 %/step]
3
Charge Roller Bias Correction
Adjusts the size of the charge roller voltage correction.
[0 to 200 / 50 / 1 V/step]
2101* Erase Margin Adjust
1
Leading Edge
Adjusts the leading edge erase margin.
The specification is 3 ±2 mm. See "Replacement and Adjustment - Copy
Adjustment" for details.
[0.0 to 9.0 / 3.0 / 0.1 mm/step]
2
Trailing Edge – Small Paper
Adjusts the trailing edge erase margin for paper of length 216 mm or less.
The specification is 3 ±2 mm. See "Replacement and Adjustment - Copy
Adjustment" for details.
[0.0 to 9.0 / 2.0 / 0.1 mm/step]
To Next Page
Loading...
