System SP Tables-2
SM Appendix 4-13 D017/D018/D019/D020/D084/D085
Appendix:
Service
Program
Mode
value of SP2101-5.
The specification is 2 ±1.5 mm. See "Replacement and Adjustment - Copy
Adjustment" for details.
[0.0 to 9.0 / 0.3 / 0.1 mm/step]
9
Rear – Right Side (Duplex 2nd Side)
Adjusts the right side erase margin on the reverse side of duplex copies.
The actual right side erase margin on the reverse side is this value plus the
value of SP2101-6.
The specification is 2 +2.5/–1.5 mm. See "Replacement and Adjustment -
Copy Adjustment" for details.
[0.0 to 9.0 / 0.3 / 0.1 mm/step]
10
Printer - Rear Trailing Edge
In printer mode, adjusts the trailing edge erase margin on the reverse side of
duplex copies.
The actual trailing edge erase margin on the reverse side is this value plus
the value of SP2101-7.
The specification is 3 ±2 mm. See "Replacement and Adjustment - Copy
Adjustment" for details
[0.0 to 9.0 / 0.0 / 0.1 mm/step]
2103*
LD Power Adjustment DFU
[50 to 170 / 129 / 1/step]
Adjusts the LD power.
Do not change the value.
2110*
Test Mode dpi
Sets the scanning resolution (dpi). DFU
[See below / 8 / 0to18]
0: 400x400 dpi
4: 300x300 dpi
8: 600x600 dpi
To Next Page
Loading...
