Ricoh D017 - Page 449

System SP Tables-2
D017/D018/D019/D020/D084/D085 4-16 SM Appendix
2301* Transfer Current Adjust
1*
Normal Paper
Adjusts the current applied to the transfer roller during copying from a paper
tray when the user uses the "Normal" paper setting.
If the user normally feeds thicker paper from a paper tray, use a higher
setting.
[0 = –2
A / 1 = 0 A / 2 = +2 A / 3 = +4 A]
2*
Thick/Thin Paper
Adjusts the current applied to the transfer roller during copying from the
by-pass tray. These settings are also used if the 2nd tray is used and special
paper is selected.
If the user normally feeds thicker paper from the by-pass tray/2nd tray
(special paper), use a higher setting. If waste toner is re-attracted from the
drum (this can occur when using an OHP sheet), use a higher setting.
[0 = –2
A / 1 = 0 A / 2 = +2 A / 3 = +4 A]
3*
Duplex Side 2
Adjusts the current applied to the transfer roller during copying from the
duplex unit when the user uses the "Normal" paper setting.
Use this SP when the image on the rear side of the paper has a problem
caused by poor image transfer.
[0 = –2
A / 1 = 0 A / 2 = +2 A / 3 = +4 A]
4*
Cleaning
Adjusts the current applied to the transfer roller during roller cleaning.
If toner remains on the roller after cleaning (dirty background appears on the
rear side of the paper), increase the current.
[–10 to 0 / –4 / 1
A /step]