System SP Tables-2
SM Appendix 4-17 D017/D018/D019/D020/D084/D085
Appendix:
Service
Program
Mode
5
Input – Front DFU
6
Input – Rear DFU
7
Temp Inside the Machine
Displays the temperature measured inside the machine just after power-on
(by the thermistor on the SBCU board) the last time that the fusing unit was
less than 40°C just after the machine was switched on.
The transfer current is corrected in accordance with this value.
2801
Developer Initialization
Initializes the developer and resets the TD and ID sensor outputs to their
defaults. Do this SP after you fill the PCU with developer at machine
installation and every time developer is replaced.
2802
Developer Mixing
Mixes the developer and checks Vt. The machine mixes the developer for 2
minutes and while doing this, it reads the TD sensor output (Vt). It does not
initialize the TD sensor output.
If the machine has not been used for a long time, prints may have a dirty
background. In this case, use this SP mode to mix the developer.
To Next Page
Loading...
