Ricoh D017 - Page 452

System SP Tables-2
SM Appendix 4-19 D017/D018/D019/D020/D084/D085
Appendix:
Service
Program
Mode
2901* Separation Voltage Adj
1
Front – Leading Edge
Adjusts the voltage that is applied to the separation plate during printing at
the leading edge of the paper on the front side.
If the copies have pawl marks at the leading edge, increase this voltage.
[–4000 to –1000 / –1800 / 1 V/step]
2
Front – Image Area
Adjusts the voltage that is applied to the separation plate during printing on
the image area of the paper on the front side.
If the copies have pawl marks in the image area, increase this voltage.
[–4000 to –1000 / –1800 / 1 V/step]
3
Rear – Leading Edge
Adjusts the voltage applied to the separation plate, during printing at the
leading edge of the paper on the rear side.
See SP2901 1.
[–4000 to –1000 / –2100 / 1 V/step]
4
Rear – Image Area
Adjusts the voltage applied to the separation plate, during printing at the
image area of the paper on the rear side.
See SP2901 2.
[–4000 to –1000 / –2100 / 1 V/step]
2902* Test Pattern
Prints the test patterns. Select the number of the test pattern that you want to
print. When adjusting the printing registration, select no.10 (Trimming Area
Pattern). [0 to 24 / 0 / 1 step]