Ricoh D017 - Page 565

System SP Tables-5
D017/D018/D019/D020/D084/D085 4-132 SM Appendix
5856
Remote ROM Update
When set to "1" allows reception of firmware data via the local port (IEEE
1284) during a remote ROM update. This setting is reset to zero after the
machine is cycled off and on. Allows the technician to upgrade the firmware
using a parallel cable
[0 to 1/1]
0: Not allowed
1: Allowed
5857 Save Debug Log
1
On/Off (1:ON 0:OFF)
Switches on the debug log feature. The debug log cannot be captured until
this feature is switched on.
[0 to 1/1]
0: OFF
1: ON
2
Target (2: HDD 3: SD)
Selects the destination where the debugging information generated by the
event selected by SP5858 will be stored if an error is generated
[2 to 3 /1]
2: HDD
3: SD Card
5
Save to HDD
Specifies the decimal key number of the log to be written to the hard disk.
6
Save to SD Card
Specifies the decimal key number of the log to be written to the SD Card.