Copier Installation
D017/D018/D019/D020/D084/D085 2-11 SM
Installation
Re-assembly
1. Make sure that all of the holes and tabs are engaged at [A], [B], [C], and [D]. Then push
down to lock the tabs on the front and rear end of the PCU.
2. Make sure that the holes for the screws on the front and rear end of the PCU are
aligned correctly. If the holes are not aligned correctly, make sure that the tabs at the
front, rear, and left side of the PCU are engaged correctly.
Reattach the rear screws (
x 2) first, then reattach the front screw ( x 1).
Do not push down on the top of the PCU when you attach the rear and front
screws
To Next Page
Loading...
