Copier Installation
SM 2-10 D017/D018/D019/D020/D084/D085
8. Open the developer pack [A].
9. While turning the black gear [B], slowly move the pack left and right and pour half of the
developer over the auger [C].
10. Continue to turn the black gear until the developer is level.
11. While continuing to turn the black gear, slowly move the pack left and right and pour the
remaining half of the developer over the auger until the developer is level.
Be careful. Do not spill developer on the gears and sponges.
If you accidentally spill developer on the gears or sponges, remove it with a
magnet or the tip of a magnetized screwdriver.
To Next Page
Loading...
