Dedicated Transmission Parameters
D361/D510 178 SM
Switch 03
No Function Comments
0-1
Inch-mm conversion before tx
The machine uses inch-based
resolutions for scanning. If "inch
only" is selected, the printed copy
may be slightly distorted at the other
end if that machine uses mm-based
resolutions.
If the setting is "Disabled", the bit
switch setting is used.
Bit 1 Bit 0 Setting
0 0
Inch-mm conversion
available
0 1 Inch only
1 0 Not used
1 1 Disabled
2-3
DIS/NSF detection method
(0, 1): Use this setting if echoes on
the line are interfering with the set-up
protocol at the start of transmission.
The machine will then wait for the
second DIS or NSF before sending
DCS or NSS.
If the setting is "Disabled", the bit
switch setting is used.
Bit 3 Bit 2 Setting
0 0 First DIS or NSF
0 1 Second DIS or NSF
1 0 Not used
1 1 Disabled
4
V.8 protocol
0: Off
1: Disabled
If transmissions to a specific
destination always end at a lower
modem rate (14,400 bps or lower),
disable V.8 protocol so as not to use
V.34 protocol.
0: V.34 communication will not be
possible.
If the setting is "Disabled", the bit
switch setting is used.
To Next Page
Loading...
