Ricoh D017 - Page 997

Dedicated Transmission Parameters
SM 179 D361/D510
D361/D510
Fax Option
Type
3350/3351
Switch 03
No Function Comments
5
Compression modes available in transmit
mode
0: MH only
1: Disabled
This bit determines the capabilities
that are informed to the other
terminal during transmission.
If the setting is "Disabled", the bit
switch setting is used.
6
7
ECM during transmission
For example, if ECM is switched on
but is not wanted when sending to a
particular terminal, use the (0, 0)
setting.
Note that V.8/V.34 protocol and JBIG
compression are automatically
disabled if ECM is disabled.
If the setting is "Disabled", the bit
switch setting is used.
Bit 7 Bit 6 Setting
0 0 Off
0 1 On
1 0 Not used
1 1 Disabled
Switch 04 - Not used (do not change the settings)
Switch 05 - Not used (do not change the settings)
Switch 06 - Not used (do not change the settings)
Switch 07 - Not used (do not change the settings)
Switch 08 - Not used (do not change the settings)
Switch 09 - Not used (do not change the settings)