Ricoh D037 - Page 683

System Service Mode
SM Appendix 9-149 D037/D038/D040/D041
Appendix:
SP Mode
Tables
013 Required Area: Y *ENG
014 Refresh Threshold: Bk *ENG
[0 to 255 / 49 / 1 cm
2
/m/step]
015 Refresh Threshold: C *ENG
016 Refresh Threshold: M *ENG
017 Refresh Threshold: Y *ENG
[0 to 255 / 25 / 1 cm
2
/m/step]
018 Pattern Number: Bk *ENG
019 Pattern Number: C *ENG
020 Pattern Number: M *ENG
021 Pattern Number: Y *ENG
022 Pattern Number: Upper limit *ENG
[0 to 255 / 0 / 1 time/step]
023 Toner Consumption Pattern Area *ENG
[10 to 2550 / 280 / 10
cm
2
/step]
024 Supply Coefficient *ENG
[0 to 2.55 / 1 / 0.01/step]
025 Job End Area Coefficient *ENG
[0.1 to 25.5 / 1 / 0.1/step]
026 Job End Vb Coefficient *ENG
[0 to 100 / 30 / 1%/step]
027 Job End Length *ENG
[0 to 100 / 19 / 1mm/step]
028 Job End Supply Amt *ENG
[0 to 1 / 0.45 / 0.001
mg/cm
2
/step]
029 Refresh:Page Thresh *ENG
030 Mode Counter:Bk *ENG
031 Mode Counter:FC *ENG
[0 to 1000 / 0 / 1 page/step]
[Blade Damage Prevention]
3517
Adjusts the threshold temperature for preventing the cleaning blade in the
transfer belt cleaning unit from being damaged. If the temperature is above this