SERVICE MODE TABLE
G104 5-18 SM
1911 028 Duplex Temp.: S2 *EGB [0 to 500 / 20 / 1 sheet/step]
1912
[Fusing Rotat.] Fusing Unit Roller Rotation Control
Paper Type -> TC1: Thick paper 1, TC2: Thick paper 2, OHP, SP: Special
Rotation *EGB [0 or 1 / 1 / -]
0: Off 1: On.
1912 001
When the printer is in the ready condition, the nip between the hot roller and
pressure roller is in the same position. This may cause deformation of the
rollers. Therefore, a temporary rotation prevents this problem. SP 1912 001
turns this feature on or off. SP1912-003 and 004 control this rotation.
Pre-rotation: Fusing idling
Prerotat. Speed *EGB [0 to 2 / 2 / -] 1912 002
Adjusts the speed of the fusing-unit rollers during fusing idling.
0: 1/3 regular speed, 1: Low speed, 2: Regular speed
Rotation Freque. *EGB [1 to 24 / 4 / 1 hour/step] 1912 003
Adjusts the frequency of the fusing-unit roller rotation if the machine is in the
ready condition for a very long interval.
Rotation Inter. *EGB [0 to 25 / 0.1/ 0.1 sec/step] 1912 004
Adjusts the duration of the fusing-unit roller rotation
Prerotat. Temp. *EGB
[0 to 200 / 100 / 1°C/step]
1912 005
Fusing idling is not done if the fusing unit temperature is above this value.
Prerotat. Inter. *EGB [0 to 180 / 1 / 1 min/step] 1912 006
Adjusts the duration of fusing idling immediately after the power is turned on.
Ex. Rotation Time *EGB [0 to 10 / 5 / 1 sec/step] 1912 007
Adjusts the time for extra rotation of the fusing unit rollers at the end of a job. If
the fusing motor stops before the fusing lamp turns off, the temperature can
become very high.
Prerotat. Ext. *EGB [0 to 255 / 0 / 1 sec/step] 1912 008
Adjusts the additional time for pre-rotation of the fusing rollers.
TC1: Rotat. Ext. *EGB [0 to 255 / 10 / 1 sec/step] 1912 010
Adjusts the additional time of the fusing roller pre-rotation for thick paper 1.
TC2 Rotat. Ext. *EGB [0 to 255 / 15 / 1 sec/step] 1912 011
Adjusts the additional time of the fusing roller pre-rotation for thick paper 2.
OHP: Rotat. Ext. *EGB [0 to 255 / 15 / 1 sec/step] 1912 012
Adjusts the additional time of the fusing roller pre-rotation for OHP.
SP: Rotat. Ext. *EGB [0 to 255 / 15 / 1 sec/step] 1912 013
Adjusts the additional time of the fusing roller pre-rotation for special paper.
1913 [Heating Roller] Heating Roller Control
Stand-by Temp. *EGB
[0 to 200 / 150 / 1°C/step]
1913 002
Adjusts the heating roller temperature when the machine is in the ready
condition.
To Next Page
Loading...
