Ricoh G104 - Page 357

Service Call Conditions
SM 4-23 G160/G161
G160/G161
SC
[Level]
Symptom Possible Cause/Required Action
read connection bus. Data in
SHM register incorrect.
 Defective SHM
1. Replace controller board
Timer error between ASIC and CPU
[0D05]
[B]
The CPU checks if the ASIC
timer works properly
compared with the CPU
timer. If the ASIC timer does
not function in the specified
range, this SC code is
displayed.
 System firmware problem
 Defective RAM-DIMM
 Defective controller
 Reinstall the controller system firmware.
1. Replace the RAM-DIMM.
2. Replace the controller board.
822 Self-Diagnostic Error: HDD
Timeout error/ [3004]: Command error
[3003]
[B]
When the main switch is
turned on or starting the
self-diagnostic, the HDD
stays busy for the specified
time or more.
 Loose connection
 Defective HDD
 Defective controller
1. Check that the HDD is correctly
connected to the controller.
2. Replace the HDD.
3. Replace the controller.
823 Self-diagnostic Error: NIB
MAC address check sum error
[6101]
[B]
The result of the MAC
address check sum does not
match the check sum stored
in ROM.
 Defective controller
1. Replace the controller.
PHY IC error
[6104]
[B]
The PHY IC on the controller
cannot be correctly
recognized.
Same as SC823-[6101]
PHY IC loop-back error
[6105]
[B]
An error occurred during the
loop-back test for the PHY IC
on the controller.
Same as SC823-[6101]
CÓPIA NÃO CONTROLADA
CÓPIA NÃO CONTROLADA