G179 viii SM
5.24 OUTPUT CHECK -1 .........................................................................5-143
5.24.1 MAIN MACHINE ......................................................................5-143
5.25 OUTPUT CHECK -2 .........................................................................5-149
5.25.1 1000-SHEET FINISHER (B408) ..............................................5-149
5.25.2 3000-SHEET FINISHER ..........................................................5-149
5.26 USING SP MODES...........................................................................5-152
5.26.1 TEST PATTERN PRINTING ....................................................5-152
5.26.2 SMC PRINT OUT LISTS: SP5-990..........................................5-153
5.26.3 NIP BAND WIDTH CHECK: SP1-109......................................5-153
5.26.4 MEMORY CLEAR: SP5-801 ....................................................5-154
5.27 UPDATING THE FIRMWARE...........................................................5-156
5.27.1 SETTING THE MACHINE IN FIRMWARE UPDATE MODE....5-156
5.27.2 REVIEWING THE MODULE STATUSES ................................5-156
5.27.3 HOW TO UPDATE A MODULE ...............................................5-157
Firmware Update Error .....................................................................5-158
Recovery after Power Loss...............................................................5-159
5.27.4 PRINTING THE SELF-DIAGNOSIS REPORT.........................5-159
5.27.5 HANDLING FIRMWARE UPDATE ERRORS ..........................5-159
Error Message Table ........................................................................5-160
5.28 NVRAM DATA UPLOAD/DOWNLOAD.............................................5-162
5.28.1 UPLOADING NVRAM DATA (SP5-824) ..................................5-162
5.28.2 DOWNLOADING NVRAM DATA (SP5-825)............................5-162
5.29 SD CARD APPLI MOVE ...................................................................5-163
5.29.1 OVERVIEW..............................................................................5-163
Use caution when you do the SD Card Appli Move procedure: ........5-163
5.29.2 MOVE EXEC............................................................................5-163
5.29.3 UNDO EXEC............................................................................5-164
5.30 SELF-DIAGNOSTIC MODE..............................................................5-165
5.30.1 SELF-DIAGNOSTIC MODE AT POWER ON ..........................5-165
5.30.2 SELF-DIAGNOSTIC TEST FLOW ...........................................5-166
5.30.3 EXECUTING DETAILED SELF-DIAGNOSIS...........................5-167
5.31 USING DEBUG LOG ........................................................................5-168
5.31.1 OVERVIEW..............................................................................5-168
5.31.2 SETTING UP "SAVE DEBUG LOG" ........................................5-168
To Switch Debug Log On..................................................................5-168
To Select the Target for the Debug Log File .....................................5-169
To Select Events...............................................................................5-169
To Next Page
Loading...
