Engine SP1-xxx: Feed-1
G179 5-12 SM
Re-load Temp. Ends
[0 to 60 / 0 / 1 deg]
004
Sets the reload temperature for the ends of the hot roller. This setting depends
on the target temperature.
Reload temp. = Target Temp – This SP Setting
Do not set a temperature that is higher than the setting for SP1105 2
(Roller Ends: Trays)
005 to
022
The following SPs adjust the fusing temperature at the center or ends of the
hot roller for each paper type.
005 Center: M-Thick
[100 to 170 / 155 / 1 deg]
006 Ends: M-Thick
[100 to 170 / 160 / 1 deg]
007 Center: Thick 1
008 Ends: Thick 1
[100 to 170 / 130 / 1 deg]
009 Center: Thick 2
010 Ends: Thick 2
[100 to 170 / 150/ 1 deg]
011 Center: Thin
[100 to 170 / 140 / 1 deg]
012 Ends: Thin
[100 to 170 / 145 / 1 deg]
013 Center: OHP: Plain
[100 to 170 / 150/ 1 deg]
014 Ends: OHP: Plain
015 Center: OHP: Thick
[100 to 170 / 155/ 1 deg]
016 Ends: OHP: Thick
[100 to 170 / 160/ 1 deg]
017 Center: Special 1
[100 to 170 / 150 / 1 deg]
018 Ends: Special 1
[100 to 170 / 155 / 1 deg]
019 Center: Special 2
[100 to 170 / 150 / 1 deg]
020 Ends: Special 2
[100 to 170 / 155 / 1 deg]
To Next Page
Loading...
