Ricoh G179 - Page 229

Engine SP1-xxx: Feed-1
SM 5-13 G179
Service
Tables
021 Center: Special 3
[100 to 170 / 150 / 1 deg]
022 Ends: Special 3
[100 to 170 / 155 / 1 deg]
023 Feed Waiting: Plain
024 Feed Waiting: M-Thick
025 Feed Waiting: Thick 1
026 Feed Waiting: Thick 2
027 Feed Waiting: Thin
Turns the feed waiting mode on or off for
each paper type.
[0 to 1 / 0 / 1]
0=Off, 1=On
The paper waits at the registration roller
until the fusing temperature reaches the
prescribed temperature (adjustable with
SP1105-028 to -37).
If you enable this feature, also set SP
1105-38 to a convenient value for the
customer.
028 Wait: Cent: Plain
029 Wait: Ends: Plain
030 Wait: C: M-Thick
031 Wait: E: M-Thick
032 Wait: C: Thick 1
033 Wait: E: Thick 1
034 Wait: Center Minus: Thick 2
035 Wait: Ends Minus: Thick 2
036 Wait: Center Minus: Thin
037 Wait: Ends Minus: Thin
Adjusts the offset value for each re-load
temperature to exit the feed waiting
mode.
[0 to 60 / 0 / 1 deg]
038 Waiting: Maximum Time
Sets the maximum feed waiting time.
[0 to 30 / 0 / 1 sec]
The paper is fed when the time specified
with this SP has passed even though the
fusing temperature has not reached the
prescribed temperature.
CÓPIA NÃO CONTROLADA
CÓPIA NÃO CONTROLADA