SP2-xxx: Drum-1
G179 5-26 SM
LD Power Adj.
2105*
Adjusts the LD power for each mode.
Each LD power setting is decided by the process control.
001 Process Cont. LD1
002 Process Cont. LD2
[–50 to 79 / 5 /1 ]
003 Printer LD1
004 Printer LD2
[–50 to 79 / -25 /1 ]
2106*
Poly. Rotat. Time (Polygon motor rotation time)
Pre Rot. Time
[0 to 60 / 10 /1 sec]
001
Adjusts the time of polygon motor rotation before a job.
If this is set to "0", this SP is not activated.
Post Rot. Time
[0 to 60 / 0 /1 sec]
002
Adjusts the time of the polygon motor rotation after a job.
If this is set to "0", the polygon motor never switches off in standby mode.
However, if the machine enters the energy saver mode, the polygon motor
will ignore the zero setting and switch itself off.
Test Pattern
2109
Use this SP to select a print test pattern. After you select any pattern other
than "0:None", this puts the printer in the Test Pattern Print mode. In the
Test Pattern Print mode, the test pattern can be printed by "List/Test Print" in
the "User Mode".
001 Pattern Selection
[0 to 24 / 0 /1 ]
Test pattern of the GAVD
0: None
1: Vertical Line (1 dot)
2: Vertical Line (2 dot)
13: Independent Pattern (3 dot)
14: Trimming Area
15: Hound’s Tooth Check (Vertical)
To Next Page
Loading...
