SP2-xxx: Drum-1
G179 5-30 SM
Current
[0 to 5 / 4 / 0.01]
001
Displays the TD sensor output voltage for the immediately previous print.
Average 10 printouts
[0 to 5 / 4 / 0.01]
002
Displays the average of the most recent TD sensor outputs (from the
previous 10 printouts).
Rate of Change
[-10000 to 10000 / 0 / 1]
003
Displays the rate of change in the TD sensor output.
GAIN
[0 to 255 / 0 / 1]
004
Displays the GAIN value used to calculate the on time for the toner supply
motor.
Image Pixel Count
[0 to 255 / 0 / 1]
005
Displays the image pixel count.
Developer Lot
2228*
Displays the lot number of the developer. (The lot number is embossed on
the top edge of the developer pack.)
Trans. Curr. Adj.
2301*
If the transfer current of image area is set highly than normal, the print
image is easily come out. If the leading transfer current is set as same, the
black line is come out due to exfoliation leave.
Image Area: 1st Side
[10 to 100 / 45 / 1μA ]
001
Adjusts the transfer current for printing the first side of the paper
Image Area: 2nd Side
[10 to 100 / 40 / 1μA ]
002
Adjusts the transfer current for printing the second side of the paper
003 Leading Edge: 1st Side
[10 to 100 / 20 / 1μA ]
To Next Page
Loading...
