SP2-xxx: Drum-3
SM 5-37 G179
Service
Tables
001 Near End
[0 to 10 / 0 / 1 ]
0: Not detected
1: Detected by SP2975-001
2: Vt (10) - Vref ≥ 0.2 and Vsp ≥ 0.6
3: Vt (10) - Vref ≥ 0.45
4: 0.45 > Vt (10) - Vref ≥ 0.2 and toner end counter ≥ 300
5 to 10: Not used
002 End
[0 to 10 / 0 / 1 ]
0: Not detected
1: Vsp ≥ 2.0
2: Toner end counter ≥ 90 when SP2213-001 is set to "0".
3: Toner end counter < 90 and Vt (10) > (Vref + 0.3) when
SP2213-001 is set to "0".
4: When SP2213-001 is set to "2"
5: Vsp ≥ 0.9 when SP2213-001 is set to "2"
6: Special order
7 to 10: Not used
Charge Counter
[0 to 1000000 / 0 / 1 sheets ]
2980*
Set the number of pages to print after toner and carrier initialization before
the charge input is increased to compensate for deterioration over time in
the polarity of the carrier.
The strength in the polarity of the carrier in the toner will eventually
decrease and cause lower charge output. Setting the charge output to
increase after a specified number of printouts can compensate for this
effect.
To Next Page
Loading...
