Punch Unit (B702)
SM 1-25 G179
Installation
7. Attach the slide drive unit [7] to the finisher and connect it to the punch unit ( x 2,
x 1). Push in the slide drive unit at when you attach the screw .
8. Make sure that the punch unit moves freely and is not blocked by the screws.
9. Put the side-to-side detection unit [8] in the machine. Make sure that the two pins are
engaged correctly at the front.
10. Make sure that the side-to-side detection unit moves smoothly on its rails. If it does not,
make sure that the rails are aligned with their grooves.
11. Attach the side-to-side detection unit and connect it at the rear (x 2, =x 1, x 1).
12. Pull the short connector [9] out of the connector [10], then connect the cable [10] of the
finisher (x 1).
This is the 3-pin connector.
To Next Page
Loading...
