Ricoh IJM C180F

EN 113Change fax settings
Set the dial type
Use this procedure to set tone-dialing or pulse-dialing mode. The factory-set default is Tone. Do not change the
setting unless you know that your phone line cannot use tone dialing.
NOTE : The pulse-dialing option is not available in all countries/regions.
To set the dial type from the printer control panel
1. From the printer control panel display, touch Fax.
2. Touch Setup, and then touch Preferences.
3. Touch Dial Type.
4. Touch to select Tone or Pulse.
To set the dial type from the Embedded Web Server (EWS)
1. Open the Embedded Web Server (EWS). For more information, see Open the Embedded Web Server.
2. Click the Fax tab.
3. Enter the PIN from the label on your printer, and click Submit.
NOTE: The PIN label can be found inside the front door.
4. In the Settings section, click Basic Fax Settings.
5. Select Tone Dialing or Pulse Dialing from the Tone or Pulse Dialing drop-down list.
6. Click Apply.
7. Click OK.