114 Chapter 4 Fax EN
Set the redial options
If the printer was unable to send a fax because the receiving fax machine did not answer or was busy, the
printer attempts to redial based on the settings for the redial options. Use the following procedure to turn the
options on or off:
• Busy Redial : If this option is turned on, the printer redials automatically if it receives a busy signal. The
default is On.
• No Answer Redial : If this option is turned on, the printer redials automatically if the receiving fax
machine does not answer. The default is Off.
• Connection Problem Redial : If this option is turned on, the printer redials automatically if there has
been a problem connecting with the receiving fax machine. Connection problem redial works only for
sending faxes from memory. The default is On.
To set the redial options from the printer control panel
1. From the printer control panel display, touch Fax.
2. Touch Setup, and then touch Preferences.
3. Touch Auto Redial.
4. Touch Busy Redial, No Answer Redial, or Connection Problem Redial to switch it on or off.
To set the redial options from the Embedded Web Server (EWS)
1. Open the Embedded Web Server (EWS). For more information, see Open the Embedded Web Server.
2. Click the Fax tab.
3. Enter the PIN from the label on your printer, and click Submit.
NOTE: The PIN label can be found inside the front door.
4. In the Settings section, click Advanced Fax Settings.
5. Select On or Off from the Busy Redial drop-down list.
6. Select On or Off from the No Answer Redial drop-down list.
7. Click Apply.
8. Click OK.
To Next Page
Loading...
