4.Service Tables
116
mode
0: MH only
1: Disabled
If the setting is "Disabled", the bit switch setting is used.
6-
7
ECM during
transmission
Bit 7: 0, Bit 6: 0 = Off
Bit 7: 0, Bit 6: 1 = On
Bit 7: 1, Bit 6: 0 = Not
used
Bit 7: 1, Bit 6: 1 =
Disabled
For example, if ECM is switched on but is not wanted when sending to a
particular terminal, use the (0, 0) setting.
• V.8/V.34 protocol and JBIG compression are automatically disabled
if ECM is disabled.
• If the setting is "Disabled", the bit switch setting is used.
Switch 04 - Not used (do not change the settings)
Switch 05 - Not used (do not change the settings)
Switch 06 - Not used (do not change the settings)
Switch 07 - Not used (do not change the settings)
Switch 08 - Not used (do not change the settings)
Switch 09 - Not used (do not change the settings)
E-mail Parameters
The initial settings of the following e-mail parameters are all "0" (all parameters disabled).
Switch 00
No FUNCTION COMMENTS
0 MH Compression mode for e-mail
attachments
0: Off
1: On
Switches MH compression on and off for files attached to e-
mails for sending.
1 MR Compression mode for e-mail
attachments
0: Off
1: On
Switches MR compression on and off for files attached to e-
mails for sending.
2 MMR Compression mode for e-mail
attachments
0: Off
1: On
Switches MMR compression on and off for files attached to e-
mails for sending.
3-
6
Not used
Do not change these settings.
7 Designates the bits to reference for
compression method of e-mail
The "0" selection (default) references the settings for Bits 00,
01, 02 above. The "1" selection ignores the selections of Bits
To Next Page
Loading...
Need help?
General
