SC8xx: Overall System
488
No. Type Details (Symptom, Possible Cause, Troubleshooting Procedures)
SC874-12 D Delete all error (Delete data area) : No designated partition
SC874-13 D Delete all error (Delete data area) : No device file
SC874-14 D Delete all error (Delete data area) : Start option error
SC874-15 D Delete all error (Delete data area) : No designated sector number
SC874-16 D Delete all error (Delete data area) : failure in performing hdderase
SC874-41 D Delete all error (Delete data area) : Other fatal errors
SC874-42 D Delete all error (Delete data area) : End by cancellation
SC874-61
to 65
D Delete all error (Delete data area) : library error
SC874-66 D Delete all error (Delete data area) : Unavailable
SC874-67 D Delete all error (Delete data area) : Erasing not finished
SC874-68 D Delete all error (Delete data area) : HDD format failure (Normal)
SC874-69 D Delete all error (Delete data area) : HDD format failure (Abnormal)
SC874-70 D Delete all error (Delete data area) : Unauthorized library
SC874-99 D Delete all error (Delete data area) : other errors
An error occurred while data was being erased on HDD or NVRAM.
• Error detected in HDD data delete program
• Error detected in NVRAM data delete program
• The “Delete All” option was not set
•
Turn the main power switch off and back on, and then execute "Erase All Memory" in
UP mode again. (However, if there is a defective sector or other problem with the hard
disk, the error will persist even after trying the above.)
• If the "Delete All" option is not installed when this error occurs, install the option.
No. Type Details (Symptom, Possible Cause, Troubleshooting Procedures)
SC875-01 D Delete all error (HDD erasure) (hddchack –i error)
SC875-02 D Delete all error (HDD erasure) (Data deletion failure)
An error was detected before HDD/data erasure starts. (Failed to erase data/failed to logically
format HDD)
• HDD logical formatting failed.
• The modules failed to erase data.
Cycle the main power off and on.
No. Type Details (Symptom, Possible Cause, Troubleshooting Procedures)
SC876-00 D Log Data Error
An error was detected in the handling of the log data at power on or during machine
operation.
To Next Page
Loading...
