Message Cause Solution and reference
"Parallel I/F board
has a problem."
An error has
occurred in the
parallel interface.
Turn off the power of the machine, wait for 10 seconds
or more after confirming that the main power indicator
is turned off, and then turn on the power.
page 19 "Turning On and Off the Power"
If the message persists even after you have turned the
power off and then on, consider repairing the machine.
"Printer font error." There is a problem
in the font file of the
machine.
Consider repairing the machine.
"Print overrun." A page image is
discarded while
printing the page.
Decrease [Resolution] in the printer driver.
See "Applying Different Print Settings Depending on the
Document Type", User Guide.
"Punch has been
cancelled."
The Punch function
was canceled
because the staple
position is specified
incorrectly.
Check the orientation of the paper and print data, and
the specified punch position.
See "Punching Holes on Printed Pages", User Guide.
"Receiving data
failed."
Transmission of
data was canceled.
Send the data again.
"Sending data
failed."
Transmission of
data from the
printer driver was
canceled.
Check that the computer is operating normally.
"Staple error
occurred. The job
has been
cancelled."
The number of
sheets that can be
stapled was
exceeded, and
printing was
canceled.
Check the number of sheets that can be stabled on the
finisher in use.
page 491 "List of Specifications for External Options"
11. Troubleshooting
402
To Next Page
Loading...
