T
echnical
B
ulletin PAGE: 6/6
Reissued: 28th-Sep-12
Model:
AG-P1/C1, AGL-P1/C1, Aries-P1.5/C1.5
Date:
06-Dec-10
No.:
RG178128c
3. Handling the Development Unit
Take note of the information in the following section to avoid the problems listed
below.
1) Variation in image density
2) Different density between left and right sides on a page
3) Toner adhesion to the development rollers
4) Scratches on the drums resulting from toner adhesion to the development rollers
5) Toner clumps caused by narrowed PG
z Always hold the prescribed locations when handling the development unit.
z Never apply external pressure to the front and rear plates and the stay.
Do not grip the face plates or the stay.
Applying external pressure will deform
the front and rear plates in vertical and
horizontal directions, resulting in
fluctuation of the PG.
Horizontal direction
ertical direction
Stay
Face plate - Rear
Hold both ends when carrying the development unit.
Face plate - Front
To Next Page
Loading...
