T
echnical
B
ulletin PAGE: 3/5
Reissued: 09-Nov-12
Model:
Aries-C1.5/P1.5, AG-C1/P1, AGL-C1/P1,
B-C3/C3.5/C4, DDP
Date:
11-May-06
No.:
RB234014o
Version Modified Points or Symptom Corrected
2. The machine stalls at a "printing in process" status in a jam where the paper is
not exit to the shift tray.
This symptom occurs only when installing the Katana-C2 and the EFI controller.
<NOTE>
Please apply firmware V1.820 or later for a configuration consisted of the Katana-
C2 and the EFI controller.
1.800:58 Symptom Corrected:
- Jam115 when changing from Standard size to Non-standard size.
Other changes:
- Moving distance of initialization has been changed to "2mm after sensor turn-
off".
1.600 <NOTE> Please apply Version (V1.600) onward when applying Plockmatic/GBC
on the Aegis.
Symptom Corrected:
1. During Plockmatic connection, JAM115 occurs when operating manual
stapling.
2. During Plockmatic connection, indication of "out of staples" does not
disappear even when staples are added after commanding a saddle-stitch
job, in which the VICTORIA-E is powered in a "out of staples" status.
3. During Plockmatic connection, when commanding saddle-stitch of more than
2 sheets consisted of a single print using
a 12x18 sheet, job completion is not correctly informed in order to start the
2nd stapling function, and results in a "still copying" status.
4. During GBC connection, sheets that are not assigned to be punched are
punched.
Changes made:
When operating saddle-stitch of more than 16 sheets at Plockmatic connection,
a the width of the exit guide plate opening will be set to 5mm.
b the shutting timing of the exit guide plate will be when 20mm of the
leading edge goes through.
To Next Page
Loading...
