Modified Points
＜Specification Changes＞
1. Creo controller is supported.
2. New function has been added to avoid decrease in productivity which
occurs when frequently activating/deactivating the units involving image
creation.
SP2-908-001 Deactivating image creation｜Extend deactivation time ON/OFF
SP2-908-002 Deactivating image creation｜Time extended
This function is not available on System Firmware 1.01 or older.
It will become available when the System Firmware is upgraded.
(Firmware Version: TBA)
3. Saddle-stitching is available with custom paper sizes on the Plockmatic.
(Available when connected to the Creo controller)
4. Potential control has been modified to avoid the problem of ID exceeding
the upper limit when powering on the machine.
＜Fixes＞
1. Problem of decrease in print speed when saddle-stitching SRA3 on the
Booklet Finisher (SR5020) has been fixed.
2. Problem of the printer halting and disabled to resume from an error when
saddle-stitching in duplex on the Plockmatic has been fixed.
3. Problem of the printer disabled to warm-up and recover from a jam or
open-door status has been fixed.
4. Problem of indicating incorrect jam locations in the downstream peripherals
when the configuration consists of both Booklet Trimmer (TR5020) and
Stacker (SK5010) has been fixed.
Apply condition:
Firmwares below to be applied together as a set.
To Next Page
Loading...
